欢迎访问!
热线电话:025-52791167 52791168 
您所在的位置: 首页 > 新闻动态
手把手教你安装和使用tescom调节阀

手把手教你安装和使用tescom调节阀

手把手教你安装和使用tescom调节阀

详细介绍

手把手教你安装和使用tescom调节阀
tescom调节阀的安装是应该重点注意的问题,安装质量的好坏直接关系到调节阀的使用情况。安装过程中应注意以下哪些问题呢。
1调节阀在安装之前,必须仔细地清除阀门在储存期间所累积的尘土,在安装过程中也要保持清洁。因为灰尘会使阀座和内件损坏。为了保持清洁,通常在当天未焊的法兰端部装上盖板。
2调节阀安装时,阀体上的箭头应与介质流向一致。
3  调节阀是精密构件,如果它们受到管道变形的力,将影响正常的工作。因此,法兰与管道安装应垂直并且位置准确避免管道的变形,并且,管道要适当支撑一下,以防止它在阀门重量作用下发生弯曲和变形。  
4调节阀在与管道安装时必须特别小心。若调节阀与管道焊接时不注意,未能消除应力,则会产生变形的情况。焊接时,必须严格避免焊渣飞入阀门内,焊渣的存在有损阀门的使用性能,如果焊渣直接溅在阀芯上,轻则直接影响调节阀的动作,重则损坏阀芯与阀座。  

5管道在试压和吹除时,调节阀应拆下,用相应的直管段相连以防止焊渣等杂物卡在阀芯与阀座之间。拆下的调节阀开口法兰端部应用塑料布包扎牢固。

Hand in hand teaching you how to install and use tescom regulating valves

The installation of the  tescom  regulating valve is a key issue that should be paid attention to, and the quality of installation directly affects the use of the regulating valve. What are the following issues to pay attention to during the installation process.

Before installing the regulating valve, it is necessary to carefully remove the accumulated dust during storage and maintain cleanliness during installation. Because dust can damage the valve seat and internal components. To maintain cleanliness, a cover plate is usually installed at the end of the flange that has not been welded on the same day.

When installing the regulating valve, the arrow on the valve body should be aligned with the flow direction of the medium.

3 regulating valves are precision components, and if they are subjected to the force of pipeline deformation, it will affect their normal operation. Therefore, the flange and pipeline installation should be vertical and accurately positioned to avoid deformation of the pipeline, and the pipeline should be appropriately supported to prevent bending and deformation under the weight of the valve.

4. Special care must 

TESCOM减压阀44-1100.jpg